![]() ![]() ‘Panic/locator’ feature Entering ‘Winter’ mode Press and hold the BLACK button of the remote for 3 seconds with the ignition switched OFF to enter ‘panic/locator’ mode. ‘Sleep’ mode All alarm systems use a small amount of current during operation and if the machine is to be left for an extended period with the alarm armed we recommend the use of a battery conditioner (such as the Datatool Smart Charger) to maintain the battery charge level. After the long audible tone, the siren will beep and the LED will flash a number of times to indicate what triggered the alarm system. The system includes a diagnostic mode, which allows you to identify the circuit that triggered the alarm system. The indicators will flash twice to indicate the alarm has been armed and then indicators will flash three further times to confirm the movement sensors have been turned OFF.ĭisarming the system after it has been triggered If the system has been triggered in your absence, a long audible tone will be heard when the alarm system is disarmed using the transmitter. To disarm the system from the armed state, simply To arm the alarm system but have both the movement and nudge sensors turned off press the BLACK button within 10 seconds of arming the system with the GREY button. Fully arming the alarm system Arming the system To fully arm the alarm system to give movement, nudge, trigger switch and battery back-up coverage, press the GREY button on the remote control within 45 seconds of turning the ignition off.Īrming the system without the Disarming the system movement sensor (‘Ferry’ Mode). ![]() We advise you to carry the quick reference card with you for roadside guidance. For a more basic explanation refer to the credit card sized instructions (S4 Quick reference) supplied. Operating the alarm system This section explains fully how the alarm system works. To replace the battery remove the small screw from the ‘key end’ of the remote and split the two halves of the case. ![]() As the battery within the remote control comes to the end of its life, you will notice a reduction in its range and the battery should be replaced. ![]() Normal range for the remote control is around 10 metres. This battery will normally last at least 12 months.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |